Raymond Mill is a device commonly used for ore grinding. Sometimes it will encounter the problem of air duct blockage during operation. Once it happens, it must be stopped and cleaned immediately, otherwise it may cause greater losses. So, what are the reasons for this problem?
♦♦ The main reasons for the blockage of the air duct of Raymond mill:
1. Insufficient fan power:
If the air volume generated by the fan is insufficient, the material cannot flow normally in the air duct, which will cause accumulation. Therefore, it is very important to ensure the normal operation of the blower to avoid the wind force being too small to effectively transmit the material.
2. Uneven feeding:
Uneven feeding of equipment is one of the main reasons for air duct blockage. When the finished powder cannot be discharged smoothly from the air duct under the action of the blower in time, the powdery material will accumulate in the air duct, causing blockage. Therefore, it is necessary to maintain continuous and uniform feeding to avoid air duct blockage.
3. Dust collector failure:
When the dust collector fails to work properly, a large amount of dust particles will accumulate in the air duct, causing air duct blockage. Therefore, regularly checking the air permeability of the dust collector to ensure its normal operation is the key to preventing air duct blockage.
♦♦ Solutions to Raymond mill air duct blockage:
1. Regularly check the equipment:
Especially when abnormal conditions occur during the production process, the machine should be stopped for inspection immediately, and the blockages in the air duct should be cleared in time to ensure that the air duct is unobstructed.
2. Ensure stable material supply:
Avoid insufficient or excessive materials, reasonably design the feed port, and achieve precise control of the feed.
3. Strengthen the drying of materials:
Avoid excessive moisture in the materials, regularly check and maintain the equipment, and avoid equipment overload and wear.
4. Keep the blower in normal operation:
Ensure that the rated power and working voltage of the blower are normal to avoid too little wind to transport the materials.
Pls contact us if you have need for powder processing line. VEST Engineering team and managering team will service for your project and issued detailed layout drawing.
Explore NOW!!!
