I believe everyone is familiar with ceramics. More than 10 billion square meters of ceramics can be produced every year, and a large number of defective products and waste will be generated during the processing. In the past, the main method for enterprises to deal with waste was mainly stacking and landfilling, which caused great harm to the ecological environment.
So how to deal with ceramic waste? What equipment can be used for processing? The following VEST will introduce it to you:
♦♦ How to deal with ceramic waste?
With the widespread dissemination of concepts such as green development and sustainable development, there are currently new ways to deal with ceramic waste, mainly including reuse as building materials, artistic creation, high-temperature treatment, chemical and physical treatment. These methods not only help to recycle and reuse resources, but also reduce environmental pollution to a certain extent.
Comparison of ceramic waste before and after treatment
Among them, the reuse of building materials has better effects and can bring some benefits to everyone. It is mainly to crush and grind ceramic waste to obtain stones of different specifications, which are used in building concrete fillers, refractory materials, building materials and cement coatings.
♦♦ What machine is good for processing ceramic waste?
Ceramic waste is mainly composed of inorganic non-metallic materials, with high chemical stability, good wear resistance, strong pressure resistance, hard texture, and is not easy to break and grind. It has higher requirements for equipment. Overall, the use of jaw crusher and Raymond mill for processing has better results.
01 Jaw Crusher
It is generally used for coarse crushing and is suitable for large pieces of ceramic waste. Its core components are a pair of movable jaw plates and fixed jaw plates. The eccentric shaft driven by the motor makes the movable jaw perform periodic reciprocating motion, forming an extrusion and splitting effect on the material to complete the work. Its crushing chamber is deep and there will be no dead zone.
Optimize the motion parameters, the lower stroke is large, and the crushing ratio is larger. At the same time, the wedge block is used to adjust the discharge port. The finished product can be adjusted and the particle size is uniform. The motor seat and the main machine are integrated, which makes installation easy and saves space.
02 Raymond Mill
After the ceramic waste is processed by the jaw crusher, it usually needs to be further finely ground. The Raymond mill can grind it into 80-360 mesh ceramic powder.
From the rough processing of raw materials to transportation to powder making and packaging, it can form a production system with strong completeness and small footprint. Through the joint action of the analyzer and the fan, it can meet different usage requirements. The finished fine powder has good quality, uniformity, high sorting accuracy, and the fineness can be adjusted according to demand. The main machine transmission device adopts a closed gear box and pulley, and the transmission is stable. The electrical system adopts centralized control, which can basically realize unmanned operation and improve the operation efficiency.
